1)
Strip back outer sheath.
Strip insulation from each conductor and tin dip.
Thread on to cable:- clamp, thrust ring (or packing piece), union gasket, outlet nut, outlet and outlet gasket.
Fit insulation sleeves to conductors.

2)
Solder conductors to connector contacts.
Slide insulation sleeves over solder joints.
Position outlet gasket and outlet at rear of connector and secure with outlet nut.
Slide union gasket into neck of outlet. Screw clamp on to outlet.
Secure clamp to cable by screwing down clamp jaw.

next wiring instruction>>
<<previous wiring instruction