|
1)
Thread on to cable union nut and
outer ferrule.
Strip back outer braid and sheath.
Thread on to cable inner ferrule and position under braid.
Force outer ferrule over inner ferrule and braid.
Trim off any braid which may protrude between ferrule flanges.
Compress braid back down cable.
Thread on to cable sealing ring outlet nut and outlet.
Comb out braid on screened leads and twist into tails.
Strip insulation from conductors and ETH lead and tin dip.
Fit insulating sleeves to conductors and ETH lead and solder to
connector contacts, cover joints with insulating sleeves.
Fit bonding clip tightly over end of sheath.
Clip screen tails under tags of bonding clip and solder.
Solder ETH lead to tag on bonding clip.
Position outlet gasket and outlet at rear of connector and secure with
outlet nut.
Slide sealing ring into neck of outlet.
Pull forward ferrules and braid up to outlet and secure with union nut.
|
MULTICORE
CABLE WITH OUTER COLLECTIVE SCREEN AND INDIVIDUALLY SCREENED H.T. LEADS
|
|
2)
Strip outer sheath and collective screen.
Thread on to cable union nut, thrust ring (or packing piece), union
gasket, compression ring and cable sleeve.
Comb out collective screen, fold back over sheath and tape down.
Thread on to cable outlet nut, outlet and outlet gasket.
Comb out braid on screened leads and twist into tails.
Strip insulation from conductors and ETH lead and tin dip.
Fit insulating sleeves to conductors and ETH lead and solder to
connector contacts.
Cover joints with insulating sleeves.
Bind over leads with heat resistant tape and fit bonding clip tightly
over tape.
Clip screen tails under bonding clip tags and solder.
Solder ETH lead to bonding clip tag.
Position outlet gasket and outlet at rear of connector and secure with
outlet nut.
Slide cable sleeve into neck of outlet. Remove tape from braid and fan
out.
Position compression ring on the end of outer sheath.
Slide forward union gasket adjacent to compression ring.
Gently push cable into neck of outlet trapping braid between outlet and
compression ring.
Trim off braid at rear of compression ring and screw union nut into
outlet.
|
MULTICORE CABLE WITH INNER COLLECTIVE
SCREEN AND INDIVIDUALLY SCREENED H.T. LEADS
 |
